CORRECT CRAFT 200-CB Manuale del Proprietario Scaricare il pdf (Pagina 151)

6-12

Section 6

When the engine starts, move the throttle lever back until the

engine is running about 2,500 rpm or less. Check the gauges for

normal readings and let the engine run for a minute to burn the

excess fuel. If the gauge readings are abnormal, stop the engine

and contact your Nautique dealer. When the engine runs normally,

check the engine for fuel, water and exhaust leaks. If there are

leaks, stop the engine and correct them before you continue.

NOTICE

Read the “Notice to Dealer” located in your Skipper’s Kit. It

contains pre-delivery checks and adjustments which must be

performed by your Nautique dealer. It is still the boat owner’s

responsibility to make sure they were performed. This will also help

you become more familiar with your boat and its systems. If you

have any questions regarding this notice, contact your Nautique

dealer.

After your initial run:

• Check the engine oil level

• Check the transmission oil level

• Check for leaks (water, fuel and oil)

• Check that engine frame bolts and mounts are tight

• Check that throttle and shift control operates correctly

NOTICE

If the engine backfires when you try to start it, the problem may be

more serious than flooding.

• DO NOT CONTINUE TRYING TO START THE

ENGINE.

• CONTACT YOUR NAUTIQUE DEALER OR A

QUALIFIED TECHNICIAN TO CORRECT THE

PROBLEM.

DO NOT keep trying to start the engine under these conditions.

Engine damage or personal injury can result.

D-Drive Sec 6_2013_Nautique Ski Sec 6.qxd 6/4/12 1:41 PM Page 6-12

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 209 210

Nessun commento

CORRECT CRAFT 200-CB Manuale del Proprietario Pagina 151